Parallel DC circuits Lab Report Example | Topics and Well Written Essays - 500 words

Parallel DC circuits - Lab Report Example Hence, NI Multisim is an essential software that enables the user to observe the operation through simulation without performing that operation. Simulation software is play an important role in understanding how circuits operate in electronics. Electronic simulation software applies mathematical models to show the behaviour of an actual electric circuit. Electronics simulators include Circuitlogix, electronic work bench, NI Multisim among others. By simulating a circuit’s behaviour and response before building it, greatly improves efficiency and provides insights and relevant information concerning the behaviour and stability of electronics circuit designs. In many electrical circuits, it is important to determine the rate at which electrical energy is transferred into other forms of energy. To calculate power P for electrical appliances, we find the product of the current (A) through it and the Potential difference (V) across it. Thus, For resistors in series, the same current flows each of the resistors whereas the total sum of the voltage across each resistor equals to the total voltage applied. Therefore, the combined resistance is given by To study various waveforms on the DSO, the 3MHz Function Generator (TG300 Series) was connected to CH1 of DSO (Tektronix) using BNC leads. A sine wave of 1 kHz frequency and a root mean square voltage of 1.4145V was displayed on the screen. The period of the sine wave was determined using equation 1 in the introduction. Furthermore, the peak to peak voltage of a sine wave was measured and recorded as required. The waveforms and its FFT graphs were then printed out using the PC communication software. Similarly, a square wave with parameters 2 kHz frequency and 2Vpeak was shown on the screen. The period of the waveforms and the peak-to-peak voltages were determined. The FFT graphs were printed out as required. The above procedure was repeated for 1.5 kHz, 2Vpeak

Literature review of my research about Dual authority in matrix Essay

Literature review of my research about Dual authority in matrix organization - Essay Example This resulted in the creation of a structure in which a number of employees were working under two heads, the department head or the project manager of the interdisciplinary project team. When this structure was depicted in paper, it was found that the crossing of the organizational lines could be represented in the form of grids or a matrix. Henceforth it was termed as matrix organizations (Kuprenas, 2003, p.1). When it is compared with the other forms of organizational structures, it is viewed as a combination of the traditional hierarchy which is overlaid with some form of lateral authority, influence or communication. The overlay creates a combination of commands, one which is long the functional aspects of the project and another which are along the project lines. Assuming the complexities of the project management in the business world of today, matrix structures are primarily used where the requirement of technical assistance across many different areas are required (Kuprenas, 2003, p.1). This structure is especially preferred in large scale consulting, the construction and the aerospace industry. One of initial and first users of the structures was Bureau of Engineering in the City of Los Angeles. However, certain problems were faced during the implementation of the same (Kuprenas, 2003, p.1). Implementation Challenges of the Matrix structure Research shows that implementation of the matrix structure in any organizational structure is difficult. Implementation of the matrix design in the Bureau of Engineering came with a number of difficulties. The Bureau experienced a number of confusions and conflicts with regards to the responsibilities and roles of the functional manager